Operation; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL 34.111.30 Originalbetriebsanleitung

Anleitung_RG_CT_18_Li_SPK7:_
To ensure that the NC battery pack provides long
service you should take care to recharge it promptly.
Recharging is always necessary when you notice a
drop in the performance of your cordless grass
trimmer.
Never fully discharge the battery pack. This will
cause it to develop a defect.

6. Operation

Your grass trimmer will work at its best if you
observe the following instructions:
Never use the grass trimmer without its safety
devices.
Do not cut grass when it is wet. The best results
are had on dry grass.
To switch on your grass trimmer, press the
safety
lock-off and the ON/OFF switch (Fig.1/Pos. 2).
To switch off your grass trimmer, let go of the
ON/OFF switch (Fig. 1/Pos. 2).
Do not move the grass trimmer against the grass
until the switch is pressed, i.e. wait until the
trimmer is running.
For the correct cutting action, swing the grass
trimmer to the side as you walk forward, holding
it at an angle of approx. 30° as you do so (see
Figure 19-20).
Make several passes to cut long grass shorter
step by step from the top (see Figure 21).
Use the guard hood to prevent unnecessary
wear.
To avoid unnecessary wear, keep the grass
trimmer away from hard objects.
Using the grass trimmer as an edge trimmer
The grass trimmer can be adjusted as follows to trim
the edge of lawns and beds.
Remove the battery (Fig. 15 + 16)
Press the setting knob (Fig. 10 / Item A)
Press and hold the setting knob and turn the top
handle through 180° until it locks.
The grass trimmer can thus be adjusted for use
as an edge trimmer for making vertical cuts on
the grass (Fig. 18).
18.01.2010 10:06 Uhr Seite 13
7. Cleaning, maintenance and ordering
of spare parts
Before putting away or cleaning the grass trimmer,
pull out the battery pack (Fig. 15 and 16).
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Remove deposits from the guard hood with a
brush.
7.2 Replacing the blade (Fig. 11+12)
IMPORTANT! Make sure that you remove the
battery pack before replacing the blade
(Fig. 15-16).
To remove the blade, push the blade inwards
and remove via the larger opening as shown in
Figure 11.
To fit the new blade, proceed in reverse order.
Make sure the blade locks into place correctly as
shown in Figure 12.
7.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Spare blade art. no.: 34.057.26
GB
13