Samsung SMT-190Dx Anleitung Seite 39

USER'S MANUAL
3. Network Ports Configuration
It sets the HTTP Port number to use when the
SMT-190DN Server communicates with a Client PC.
The present SMT-190DN Server uses HTTP Port (80).
- HTTP Port
1) This is the port the Client PC uses to connect to the
web page of the SMT-190DN Server.
Depending on the environment of the network, its
value may vary.
) The default value is 80 and can be assigned from
10 to 6555 maximum.
 If you change the value of the HTTP Port, you should
type in the new one with the address of the
SMT-190DN Server in the address window of the
web browser.
(Ex. If the IP address of the SMT-190DN Server is
19.168.1.100 and the HTTP Port :8080, http://19.1
68.1.100:8080.)
) Click Apply button to apply the present setting.
CAUTION
Set the port to be used when connecting to
SMT-190DN in Internet Explorer. The port setting is
used for various network configurations, for example
when connecting to a network with firewalls.
4. View Network Status
This is a menu to see the general status of the network
setting of the SMT-190DN Server.
- Menu Configuration
Common To check the status of the Gateway, DNS 1,
Status and DNS .
LAN To check the status of the STATIC IP
Status Address, Netmask, and MAC Address.
PPPoE If the PPPoE service is connected, the
Status Link is up. At this time, the service IP and
NETMASK can also be checked.
If the PPPoE service is not connected, the
Link is down. The existing setting will be
recalled if you press Reload button.
5. DDNS Configuration
- Menu Configuration
Service Select Enable or Disable
DDNS
Websamsung.net
Server
The domain name of this system is
Note
wff0000.websamsung.net
CAUTION
Since the connection to SMT-190DN is made using
domain names (EX : http://wff0000.websamsung.net)
that are automatically registered in Samsung's DDNS
server when using a DHCP configuration; the IP
address, Subnet Mask and Gateway in the Network
Tab of Admin Mode do not need to be entered.
Eng-9