Applicable Model - Hitachi RCIM-0.4FSRE Installations- Und Betriebshandbuch

INSTALLATION OF OPTIONAL AIR PANEL
13 INSTALLATION OF OPTIONAL AIR PANEL

13.1 APPLICABLE MODEL

This air panel is applicable to the following indoor unit model:
Air panel
P-AP56NAM
P-AP56NAMS
P-AP56NAMR
The supplementary information about the purchased products is supplied in a CD-ROM, which can be found bundled with the
outdoor unit.
13.2 TRANSPORTATION AND HANDLING
1 Transport the air panel without unpacking as close to the
installation location.
2 Mount the air panel as soon as possible after unpacking.
3 When the air panel is placed on the floor after unpacking,
place it with the rear side downward (the surface to fit the
indoor unit body) on an insulation material, etc. However,
do not leave the air panel on the floor for long time. It may
cause air leakage due to scratch the seal packing.
13.3 BEFORE INSTALLATION
1 Check to ensure that the following accessories are packed with the air panel.
Name
Long Screw (M5 Cross Screw)
If any of these accessories are not packed in the packing, please contact your contractor.
13.4 INSTALLATION
!
C A U T I O N
Pay attention to perform the installation work at high-place using a
stepladder, etc.
?
N O T E
• Do not move the louver by hand.
• If moved, the louver mechanism will be damaged.
• In addition, do not apply an excessive force to the air outlet part to
prevent the breakage.
1 The suspension height of the indoor unit should be referred
to "Installation & Maintenance Manual" of the indoor unit.
2 Do not touch the louver during the installation work.
3 Remove the air inlet grille from the air panel.
While pushing both ends of knobs at the air inlet grille
toward the arrow direction, open the air inlet grille until the
angle of approximately 45° from the air panel surface. After
lifting the air inlet grille keeping it inclined, draw the air inlet
grille forward.
22 PMML0550 rev.0 - 12/2020
Indoor unit model
RCIM-(0.4- 2.5)FSRE
Quantity Purpose
4 For fixing air panel
In addition, if the air panel is placed with the surface
downward, the louver mechanism may be damaged due to
touch the louver to the floor, etc.
4 Do not move the louver by hand. If moved, the louver
mechanism will be damaged.
(Remove the filament tape (4 portions) fixing the air filter.)
Air inlet grille
Corner pocket
cover (4 portions)
?
N O T E
Although the air inlet grille can be opened until the angle of 90° from the
air panel surface, it can not be removed from the air panel.
Air panel
Knob