Operation; Requirements For The Placement Area; Setup - Jung JLA-e 5/12 G Betriebsanleitung

4. Operation

Electrical voltage warning:
If the required precautionary measures
are not taken, injuries or damage could
result from electrical voltage.
Before operating the driven trolley, the operating per-
sonnel (i.e., anyone assigned to carry out the intended
lifting and transport work) must read these operating
instructions in full. All instructions related to lifting also
apply analogously to lowering of a load.

4.1 Requirements for the placement area

The trolley must be placed on a flat, clean, horizontal,
sufficiently load-bearing, non-slip, dry surface. The
trolley must stand securely when the goods to be
transported are loaded.
The transport load must be statically rigid and tilt-resis-
tant. The surface that is placed on the trolley must be
suitable for this purpose. In particular, ensure sufficient
size, compressive strength, stability and slip safety.
The total weight of the transport load and the position
of the centre of gravity must be determined before
lifting and moving. Therefore the centre of gravity must
first be determined (see next chapter).
DANGER
Before the driven trolley is used for the load to be
transported, the centre of gravity of the load to be
transported must be determined first. Otherwise,
tipping or slipping can lead to injuries or even to fatal
accidents. Always determine the centre of gravity before
using JUNG trolleys.
- 38 -
Electrically driven trolleys JLA-e 5/12 G, JLA-e 15/30 G and JLA-e 25/50 H

4.2 Setup

JLA-e 5/12 G
2
> Stick the rechargeable battery (1) (from here on
referred to simply as the "battery") onto the
trolley (2).
> Screw the battery (1) onto the trolley.
JLA-e 15/30 G / JLA-e 25/50 H
2
> Stick the battery (1) onto the shaft (2).
> Lock the latches (3) in place on both sides.
JLA-e 5/12 G / JLA-e 15/30 G / JLA-e 25/50 H
> Connect the battery cable of the trolley to the
steering gear with the plug (4).
3
4
© JUNG Hebe- und Transporttechnik GmbH
1