Using The Antennas; Performing Initial Setup - Sonoro STREAM SO-411 Bedienungsanleitung

Do not block the infra-red sensor on the STREAM and the infra-red
transmitter on the remote control during use.
3.4

Using the antennas

1. Pull the arms of the rod antenna apart and align the FM/DAB antenna so that
you have the best possible reception.
2. Lift Wi-Fi antenna upwards.
3.5

Performing initial setup

When STREAM is powered on for the first time, the "Language" (to be used in the
display) selection shows on the display. Afterwards, the Privacy policy statement
appears and needs to be accepted by pressing (OK) on remote control or
navigation knob. Then, the "Setup wizard" appears on the display. Follow the
instructions below to configure some initial
1. When the "Setup Wizard" is displayed, press
rotate the navigation knob) to select "YES" and then press OK to start the
setup.
2. You are then prompted to select:
Time format (12 or 24-hour)
•
Source of time & date auto
•
update).
Depending on the selection you have made, follow the instructions on the
display to further set up date and time, time zone, daylight saving or wireless
network. Rotate the navigation knob on STREAM or press the navigation
buttons on the remote control to make selections and then press OK to
confirm (see chapter "Using the menus").
60
settings.
+
or
update (Update from radio, Internet or no
–
on the remote control (or
© sonoro audio GmbH 2022