Using The Antennas; Performing Initial Setup - Sonoro sonoroSTREAM SO-410 Bedienungsanleitung

Do not block the infra-red sensor on the sonoroSTREAM and the infra-red
transmitter on the remote control during use.
3.4

Using the antennas

1. Pull the arms of the rod antenna apart and align the FM/DAB antenna so that
you have the best possible reception.
2. Lift Wi-Fi antenna upwards.
3.5

Performing initial setup

When sonoroSTREAM is powered on for the first time, the "Language" (to be used
in the display) selection appears on the display. Then, the "Setup wizard" appears
on the display. Follow the instructions below to configure some basic settings.
1. When the "Setup Wizard" is displayed, press
rotate the navigation knob) to select "YES" and then press OK to start the
setup.
2. You are then prompted to select:
Time format (12 or 24-hour)
•
Source of auto update (Update from radio, Internet or no update).
•
Depending on the selection you have made, follow the instructions on the
display to further set up date and time, time zone, daylight saving or wireless
network. Rotate the navigation knob on sonoroSTREAM or press the
navigation buttons on the remote control to make selections and then press
OK to confirm (see chapter "Using the menus").
When Update from Internet is selected, Wi-Fi connection must be first
established. When entering the key of your wireless network, rotate the
navigation knob on sonoroSTREAM or press the navigation buttons on the
remote control to select a character and then press OK to confirm. To delete
the last entry, select [BKSP]. To cancel entering the key, select [CANCEL]. To
confirm the entered key, select [OK].
60
+ –
or on the remote control (or
© sonoro audio GmbH 2019