Werbung
Verfügbare Sprachen
Verfügbare Sprachen
®
HD-SDI Miniature Cameras
GB
Please read these operating instructions carefully prior to
installation and keep them for later use.
1 Applications
These high-resolution colour cameras are especially
designed for use in video surveillance systems (CCTV).
They are equipped with a 4.3 mm fixed-focus lens. Cam-
era features include automatic day/ night switching, back-
light compensation, digital noise reduction, mirror-
inverted image display, zoom, motion detection and a
masking function to cover zones that are not to be moni-
tored. The cameras are equipped with a digital output
(SDI) for high-resolution image signals (HD) and with an
analog output for testing purposes.
2 Safety Notes
The camera corresponds to all relevant directives of the
EU and is therefore marked with
.
G
The camera is suitable for indoor use only. For outdoor
mounting, the camera must be placed into a weather-
proof protection housing.
G
Protect the camera against dust, humidity and heat
(admissible ambient temperature range: -10 °C to
+50 °C).
G
For cleaning only use a dry, soft cloth; never use water
or chemicals.
G
No guarantee claims for the camera and no liability for
any resulting personal damage or material damage will
be accepted if the camera is used for other purposes
than originally intended, if it is not correctly installed or
if it is not repaired in an expert way.
If the camera is to be put out of operation defin-
itively, take it to a local recycling plant for a dis-
posal which is not harmful to the environment.
®
MONACOR INTERNATIONAL GmbH & Co. KG • Zum Falsch 36 • 28307 Bremen • Germany
HDCAM-1010
HDCAM-1020
3 Installation
1) To find the optimum place of mounting, make a test
run.
2) Use the camera support to fasten the camera to the
ceiling or the wall, for example.
3) Use a 75 Ω cable to connect the BNC jack (4) to the
SDI video input of a monitor. The maximum cable
length possible depends on the cable quality. With
the low-loss special cable KHD-1 from MONACOR,
the maximum cable length is 170 m. Repeaters (e. g.
HDEXT-206) can be inserted to support cable lengths
of several hundred meters.
4) For testing purposes, an additional analog low-resolu-
tion video signal is available at the BNC inline jack (5).
5) Connect a regulated 12 V power supply with a perma-
nent rating of 120 mA to the red inline jack (3). A low-
voltage plug 5.5 / 2.1 mm (exterior / interior diameter) is
required. Make absolutely sure to observe the correct
polarity (centre contact = +).
6) Switch on the monitor connected and align the camera
by means of the monitor image: Loosen the setscrew(s)
(2) at the camera support, and position the camera as
desired. Then tighten the screw(s) again.
4 Adjustments via the On-screen Menu
The on-screen menu is operated by means of the control
lever (1). To display the on-screen menu, press the con-
trol lever. The main menu appears:
MENU
EXPOSURE
WHITE BAL
DAY&NIGHT
BACKLIGHT
3D-DNR
IMAGE
MONITOR
SYSTEM
EXIT
To select a menu item, tilt the lever vertically ; to change
the value or to select an option, tilt the lever horizontally
↵
. When the symbol
appears behind a menu item or
option, the lever can be pressed to call up a submenu or
to activate a function.
Please refer to the reverse page of these instructions for
a tabulated list of all available setting options.
Order No. 18.3530
Order No. 18.3540
EXIT
To exit the menu, select the line
and press the lever.
If the lever is tilted to the left or the right while the menu is
not displayed, special menus will appear; the options of
these special menus are only designed for making the
basic factory settings during camera manufacturing
EXIT
and should not be changed. Select the line
menu line) to exit these special menus.
Copyright
©
by MONACOR INTERNATIONAL. All rights reserved.
5 Specifications
Image sensor: . . . . . . . . . CMOS chip, 8.5 mm (
2 megapixels, progressive
scan
Number of pixels: . . . . . . . 1920 × 1080 max.
(= last
Lens: . . . . . . . . . . . . . . . . 4.3 mm/ 1 : 2.0
Minimum illumination: . . . 1 lx (colour)
0.5 lx (B/W)
SDI video formats: . . . . . . 1080p30, 1080p25,
720p60, 720p50
Analog video output: . . . . PAL / NTSC, 1Vpp / 75 Ω
S / N ratio: . . . . . . . . . . . . . > 50 dB (AGC off)
Power supply: . . . . . . . . . 12 V , 120 mA
Admissible temperature: . -10 to +50 °C
Dimensions, weight
HDCAM-1010: . . . . . . . 30 × 30 × 20 mm, 100 g
HDCAM-1020: . . . . . . . ∅ 25 mm × 47 mm, 100 g
Subject to technical modification.
A-1552.99.01.04.2014
1
⁄
")
3
Werbung
