Handle Adjustment; Installation With Base - Joie i-Gemm 3 Bedienungsanleitung

!
Warnings not to use the infant carrier in the area of airbag deploy-
ment.
!
Note that Rearward facing infant carrier should only be installed on
forward facing passenger seats.
How to install the baby seat using the aircraft seat's safety belt:
1. Place the infant carrier opposite to the flight direction onto the
passenger seat.
2. Ensure that the carry handle is in the topmost position.
3. Place the safety belt into both light green belt guides.
4. Close the safety belt (refer to the safety instructions by the airline).
5. Tighten the safety belt by pulling the belt end.
!
The buckle of the safety belt must under no circumstances lie within
the light green belt guides.
Removal:
Open the safety belt of the passenger seat (refer to the safety instruc-
tions by the airline).
Now you can take the baby seat from the passenger seat.

Handle Adjustment

1
2
3
7
2
1
The handle of the infant carrier module can be adjusted to 3 positions.
!
Position for car, hand or stroller transportation.
To adjust the handle, squeeze the handle buttons on both sides to
release it, and then rotate the handle until it clicks into any of the 3
positions.

Installation with base

ISOFIX Installation see images
1. Unfold the load leg from storage compartment.
2. Fit the ISOFIX guides with the ISOFIX anchor points.
guides can protect the surface of the vehicle seat from being torn.
They can also guide the ISOFIX connectors.
3. Rotate the ISOFIX connectors 180 degrees until they are pointing in
the direction of the ISOFIX guides.
4. Line up the ISOFIX connectors with the ISOFIX guides, and then
click both ISOFIX connectors into the ISOFIX anchor points.
!
Make sure that both ISOFIX connectors are securely attached to
their ISOFIX anchor points. There should be two audible clicks and
the colors of the indicators on the both ISOFIX connectors should be
-1
completely green.
4
!
Check to make sure the base is securely installed by pulling on the
both ISOFIX connectors.
5. After placing the base on the vehicle seat, extend the load leg to
floor , When the load leg indicator shows green means it is
5
installed correctly, red means it is installed incorrectly.
!
The load leg has 24 positions. When the load leg indicator shows red
this means the load leg is in the wrong position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg releasing button, then shorten the load leg
upwards.
-
1 11
1
The ISOFIX
2
3
4
-3
5
8