Shoulder Harness Position; Handle Adjustment - Joie gemm Bedienungsanleitung

!
Warnings not to use the infant carrier in the area of airbag deploy-
-2
ment.
3
!
Note that Rearward facing infant carrier should only be installed on
forward facing passenger seats.
How to install the baby seat using the aircraft seat's safety belt:
1. Place the infant carrier opposite to the flight direction onto the
passenger seat.
2. Ensure that the carry handle is in the topmost position.
3. Place the safety belt into both light blue belt guides.
4. Close the safety belt (refer to the safety instructions by the airline).
5. Tighten the safety belt by pulling the belt end.
!
The buckle of the safety belt must under no circumstances lie within
the light blue belt guides.
Removal:
Open the safety belt of the passenger seat (refer to the safety instruc-
tions by the airline).
Now you can take the baby seat from the passenger seat.

Handle Adjustment

see images -
7 8
The handle of the infant child restraint can be adjusted to 3
positions.
7
To adjust the handle, squeeze handle buttons on both sides to
release it -1, and then rotate the handle until it clicks into any
8
of the 3 positions. -2
8
7
4
5
6

Shoulder Harness Position

see images -
9 10
Check that shoulder harnesses are set at the proper height.
Please choose the proper pair of shoulder harness slots
according to the child's height.
!
Shoulder harnesses must go into the harness slots nearest to
your baby's shoulders , but not above the shoulder line.
9
10
!
If the shoulder harnesses are not at proper height, the child
might be thrown from the infant child restraint when there is an
accident.
Shoulder Harness Strap
Height Adjustment
see images -
11 14
1. Press the adjustment button at the front of the seat and pull
the shoulder harnesses to loosen them.
2. At the back of the seat, take the harness ends off the metal
junction plate.
12
3. Pull the harnesses through the slots in the seat
them into the appropriate set of slots.
a. Thread the shoulder strap through shoulder harnesses.
b. Thread the shoulder harness anchor through the shoulder
harness slot.
c. Thread the shoulder strap through the shoulder harness
slot.
4. Reassemble the harness ends onto the junction plate.
11
-1,insert
13
-2
13
14
8