Getting Started - Labelmate COUNT-100 Bedienungsanleitung

Getting started

SET-UP : STEP 1
• Plug the AC/DC adaptor into a suitable AC Power Outlet. Plug the Cord on the AC/DC Adaptor into the Power Input
Jack on the bottom of the Counter Display Module.
IMPORTANT: CALIBRATION OF THE PHOTOCELL
To reliably count your labels, it is recommended to calibrate the photocell whenever you are changing labels and/or label
material. The procedure is easy:
• Load a roll of labels on the machine and position the backing paper in front of the photocell. Make sure that the labels
are tensioned when doing the calibration. The green LED should light on. If not, rotate the potentiometer till LED goes on
"green". Now put a label in front of the photocell, the LED should turn off.
U-MODELS ONLY: CALIBRATION OF THE ULTRASONIC SENSOR
• Tension the web between supply roll & take-up roll
• Push the bracket holding the sensor as close as possible towards the rolling guide shafts
• Select the ultrasonic sensor with the switch on the rear-panel of the Counter Unit
• Remove some labels and place backing paper only in the gap of the ultrasonic sensor
• Press "+" & "-" simultaneously for 1 sec, the red led will flash
• Slowly move the web back and forth 4 to 5 times for the sensor to detect the label and the backing (self-teaching)
• End moving web on backing and press "-" 1 time, all leds will switch off
• Start the unit on slow speed, the yellow led should flash for every label detected
SET-UP : STEP 2
• Plug the Control Cable (with 3.5mm plugs at each end) between the Output Jack on the bottom of the Counter Display
Module and the "EXTERNAL HALT CONTROL" jack on the CAT-3 Label Rewinder.
• The Counter is pre-programmed as a Preset Count-up Counter. Press each of the 6-digits for the count desired. This
is the number of labels you wish to pass through the Label Sensor before the Counter issues a "HALT" command to
the CAT-3 Label Rewinder.
• Pull a short strip of labels back and forth through the Label Sensor Gap and observe the count on the Counter increas-
ing. When the preset number of labels is reached, the PC-1 Counter will issue a Halt Command for the CAT-3 Label
Rewinder to stop. Pressing "RESET" will reset the count and restart the CAT-3.
• See the included detailed manual for the Pre-set Counter itself for other Counter options.
Labelmate - The World's Leading Manufacturer of Label Dispensers, Rewinders, Unwinders, Slitters & Counting Solutions