THOMSON GUARDIAN 520015 Bedienungsanleitung Seite 35

Select your 2.4 GHz Wi-Fi network, enter your network
password and press NEXT.
Android Version
Please wait while the pairing procedure takes
place. This stage can last several minutes.
In case of failure, check the Guardian module
Wi-Fi range. To do so, set up short wiring, in the
vicinity of your Wi-Fi network. Check your network
password and check that you are on 2.4GHz WiFi.
Next, perform a reset and restart the procedure (see
page 10).
Your module has been successfully paired. You can
set a name and press FINISH.
IOS Version
WI-FI RECEIVER MODULE
Your module is now operational and appears in
your dashboard. Wait until the icons change from
grey to black (indicating confirmation that the
module is connected to your WiFi network).
You can now control your gate from your
smartphone.
The icon changes to green a few seconds after gate
activation. If this does not happen and the icon
remains grey, you must have a connection problem.
Check the range and your WiFi connection. Check
also that the module is still powered.
C - INSTALLATION
9
EN