SUPAIR DELIGHT3 Betriebshandbuch Seite 52

Harness User's manual | DELIGHT3
Connecting the wing to the harness
Connecting the wing to the harness.
Without twisting the risers, connect them to the harness attachment loops using the self-locking carabi-
ners.
Check for the risers to be properly positioned and untwisted. The «A» risers must be located at the front
and facing the flight direction (see diagram).
Lastly, check for the main self-locking carabiners to be fully closed and locked in place.
Installing the accelerator
Install the accelerator by following the instructions found on page 11.
Risers A
Connect it to the wing using the split hooks.
Once the accelerator/speedbar is connected, adjust its length according to your measurements. For
correct use, there must not be any tension at the split-hook level when the accelerator/speedbar line is
fully relaxed.
Carabiners
Sellette
Flight Direction
SUPAIR | DELIGHT3 | page 21