Connecting The Remote Control; Appliance Operating (Key / Switch Functions) - Respekta CH 11050 ISB Bedienungs- & Installationsanleitung

English
A
1. Touch the Power key E, to turn the cooker hood motor ON
2. Touch the Speed key D time after time, till the motor runs at the desired speed (as low,
mid, or high) The LED display will indicate as 1-2-3-1-2... circularly.
3. Touch the Lamp key B, the light goes on, press this button again, the light is off. Please
note the Lamp is not under control of the on/off button.
4. To use the timer, touch the button A. The hood enter in to the timer status (the timer runtime
is max. 9 minutes), and the remaining runtime will be showm by counting down 9.8.7.6.... on
the LED display C. After the set time has elapsed, the hood is automatically switched off and
the lamp goes out.

Connecting the remote control

When using the remote control the first time a connection to the cooker hood mast be
established. The remote control may be able to control several cooker hoods at the same
time.
Connection process between remote control and cooker hood
Press the Power button E on the cooker hood for 5 seconds within 15 seconds after
connecting the cooker hood to the mains. The key illuminations starts to flash from one key to
the other. The cooker hood is in connection mode. Touch any button on the remote control to
confirm the connection. The connection process is complete (coded) and the remote control
can be used for speed selection, lighting and timer setting.
If you want to connect again, you will need to clear the code that has been set up previously.
To clear the code, touch the power key E for 5 seconds. The indicators light begin flashing
from one button to another. Tthe cooker is in connection mode. Then, touch the poer key E
again for 5 seconds. The previous connection code is cleared
fi200505atNEG
Oberating- and Installation Instruction cooker hoods
15. Appliance opperating
Key- / Switch functions
B C
CH 11050 ISB
CH 11050 ISW
A
B
C
D
E
D E
10
Timer ON/OFF key
Lamp OM/OFF key
LED Display
Speed selection key
Power ON/OFF key
Technical changes reserved
GB