Stihl KGA 770 Gebrauchsanleitung Seite 35

Never use connecting cords that do
–
not comply with regulations.
To reduce the risk of stumbling,
–
position and mark the connecting
cord so that it cannot be damaged
or endanger others.
To reduce the risk of electric shock:
Always connect the cord to a
–
properly installed wall outlet.
Make sure the insulation of the
–
power cord and plug is in good
condition.
After using the charger, unplug it from
the wall socket.
Operating the Power Tool
Before Starting Work
Do not operate your power tool if any of
its components are damaged.
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
On/off switch must move easily to 0
–
On/off switch must be in position 0
–
Check contacts in battery
–
compartment for foreign matter.
Fit the battery correctly – it must
–
engage audibly.
Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the power tool.
Check that the push handle is firmly
–
seated.
Check condition of housing
–
KGA 770
Check condition and security of
–
hopper.
Inspect side brooms and roller
–
brush for jammed objects and
clogged dirt – the bristles must
move freely.
Check sweeping pressure setting
–
and, if necessary, set it to match the
surface to be cleaned.
Never attempt to modify the controls
–
or the safety devices in any way.
To reduce the risk of accidents and
personal injury, do not operate your
power tool if it is not properly assembled
and in good condition.
Never operate the on/off switch with
your foot.
During Operation
In case of imminent danger or in an
emergency, switch off the power tool
immediately and remove the battery.
If a side broom or the roller brush is
jammed, switch off the power tool and
remove the battery before removing the
blockage. Wear sturdy work gloves to
reduce the risk of cut injuries from sharp
objects.
Never reach into rotating bristles – risk of
injury.
Never bump against shelving,
scaffolding, etc. while working since
there is a risk of objects toppling over or
falling from above.
Keep bystanders, especially children,
and animals away from the work area.
Never leave a running machine
unattended.
Do not leave the machine outdoors in
the rain.
Do not operate the power tool without
the hopper.
Take special care in slippery conditions,
on slopes or uneven ground.
To reduce the risk of accidents, take a
break in good time to avoid tiredness or
exhaustion.
Never work with the
power tool in the rain or in
wet or very damp
locations.
If dust levels are very high, always wear
a suitable respirator.
If there is a noticeable change in running
behavior (e.g. higher vibrations,
sluggishness), stop work and rectify the
cause of the problem.
If your power tool is subjected to
unusually high loads for which it was not
designed (e.g. heavy impact or a fall),
always check that it is in good condition
before continuing work – see also
"Before Starting Work". Make sure the
safety devices are working properly. Do
not continue operating your power tool if
it is damaged. In case of doubt, have the
unit checked by your servicing dealer.
Do not sweep up burning or glowing
objects such as cigarettes, ash or
matches – risk of fire.
After Finishing Work
Before leaving the power tool
unattended: Switch off the motor and
remove the battery.
English
33