Light Emitting Diodes (Led) On Charger - Stihl KGA 770 Gebrauchsanleitung

English
2)
During operation: Power tool cuts
out – allow battery to cool down; it
may be necessary to take the
battery out of the power tool for this
purpose.
3)
Electromagnetic interference or
fault. Take the battery out of the
power tool and refit it. Switch on the
power tool – if the light emitting
diodes still flash, the battery is
faulty and must be replaced.
4)
Electromagnetic interference or
fault. Take the battery out of the
power tool and refit it. Switch on the
power tool – if the light emitting
diodes still flash, the power tool is
faulty and must be checked by a
servicing dealer – STIHL
recommends an authorized STIHL
servicing dealer.
40
Light Emitting Diodes (LED)
on Charger
1
The light emitting diode (1) lights up
green or flashes red.
Green continuous light ...
... means the following:
The battery
is being charged
–
is too hot and must cool down
–
before it is charged
See also "Light Emitting Diodes (LED)
on Battery".
The green light emitting diode on the
charger goes off as soon as the battery
is fully charged.
Red flashing light ...
... means the following:
No electrical contact between
–
battery and charger – remove and
refit the battery
Faulty battery – see also "Light
–
Emitting Diodes (LED) on Battery".
Charger faulty – have checked by a
–
servicing dealer. STIHL
recommends a STIHL servicing
dealer.
KGA 770