Description Of Operation; Connecting Charger To Power Supply; Charging The Battery - Stihl KGA 770 Gebrauchsanleitung

Description of Operation

The power tool is operated with a
rechargeable battery. Use only STIHL
chargers to recharge the battery.
Data exchange
The power tool, battery and charger
communicate with each other. The
charger charges the battery and the
battery supplies the necessary power
only if data exchange functions properly.
For this reason you should operate your
power tool only with the approved STIHL
batteries and STIHL chargers.
KGA 770
Connecting Charger to
Power Supply
Mains voltage and operating voltage
must be the same.
Insert the mains plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.

Charging the Battery

The battery is given a charge of about
30% before leaving the factory.
Recommendation: Fully charge the
battery before using your power tool for
2
the first time.
1
Connect the charger to the power
N
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger indoors only in dry
locations at an ambient temperature
between +5°C and +40°C.
Push the battery (1) into the
N
charger (2) until you feel noticeable
resistance – then push it as far as
stop.
English
2
37