Switching Off - Stihl KGA 770 Gebrauchsanleitung

English
Guide Roller
The guide roller makes it easier to
control the sweeper along edges, e.g.
next to walls or curbs.
Hold-Down Device
The hold-down device can be pushed
down to keep the bristles close to the
ground when sweeping along edges,
e.g. next to walls or curbs.
Push down knob on hold-down
N
device.
Thermal Overload Cutout
The thermal overload cutout interrupts
the power supply if the motors are
overloaded, e.g. if a side broom or roller
brush is blocked.
42
If the overload cutout has interrupted the
power supply:
Switch off the machine – position 0 –
N
and remove the battery.
Remove blockage from side brooms
N
or roller brush.
Wait about 30 seconds for overload
N
cutout to cool down.
1
The thermal overload cutout for the side
brooms resets automatically, while the
overload cutout for the roller brush has
to be reset manually by pressing the
switch (1).
Fit the battery and switch the
N
machine on again – set on/off switch
to I.

Switching Off

Switch off the machine – position 0
N
Always remove the battery from the
power tool during work breaks and after
finishing work.
Removing the Battery
2 1
1
Press in both locking tabs (1) at the
N
same time to unlock the battery (2).
Take the battery (2) out of the
N
housing.
When the power tool is not in use, shut it
off so that it does not endanger others.
Secure it against unauthorized use.
KGA 770