Radio Controlled Clock; Manual Time Setting - Hyundai WS 2266 Bedienungsanleitung

(4) The use of 1.5 m cord Temperature Probe:
• Insert the probe plug (D8) to the jack on the right hand side of the Thermo Sensor Unit.
• Put the cable outside and leave the Thermo Sensor Unit in indoor area to avoid freezing up
the battery when the outdoor temperature is below −20 °C.
• Always use the temperature probe to sense the temperature when the temperature is between
the following range: −50 °C ~ 0 °C and +50 °C ~ +70 °C
8. TIME AND ALARM SETTING

8.1 Radio Controlled Clock:

• After batteries inserted and main unit finishes receiving the transmissions from outdoor
thermo sensor, the clock automatically starts to scan the DCF time signal.
Radio Control Icon "
(A9) flashes,
Indicating now is receiving
DCF signal
• The clock automatically scans the time signal at 3.00 a.m. every day to maintain accurate
timing. If reception fail, scanning stops ("
4.00 a.m. 5.00 a.m. and 6.00 a.m.
• The clock can be set to scan the time signal manually by holding "▼" button (B6) for 3 seconds.
Each reception takes about 5 minutes. If receptions fail, scanning stops. ("
• Stop scanning by holding "▼" button (B6) for 3 seconds.
• "DST" shown on the LCD if it is in Daylight Saving Time Mode

8.2 Manual Time Setting:

• Hold "MODE" button (B2) for 3 seconds to enter Clock/Calendar setting mode.
• Press "▲" (B4) or "▼" (B6) button to adjust the setting and press "MODE" button (B2) to
confirm each setting.
• The setting sequence is shown as follow: Weather forecast, RCC ON/OFF, Time Zone,
12/24Hour, Hour, Minute, Weekday language, Year, Month-Day Sequence, Month, Day, Tem-
perature Unit
• 10 languages can be selected in Day-of-week, they are: German (GE), English(EN), Fren-
ch(FR), Italian(IT), Dutch(NE), Spanish(ES), Danish(DA), Czech(CZ), Russian(RU), Norwegi-
an (NO)
• The Time zone is used for the countries where can receive the DCF time signal but the time
zone is different from the German time.
• When the country time is faster than the German time for 1 hour, the zone should be set to +1.
Then the clock will automatically set 1 hour faster from the signal time received.
Note:
The Time Setting Mode will automatically exit in 15 seconds without any adjustmen
" (A9) flashes on the LCD.
(A9) turns on,
Indicating signal received
successfully
" on LCD disappear) and repeats again at
EN - 31
(A9) disappear,
Indicating signal reception
failed
" on LCD disappear).
EN