(2) Humidity
•
The humidity measurable range is 20% ~ 99%. If the current humidity measurement is
lower than 20%, the LCD would display
99%, the LCD would display 99%
(3) Maximum / Minimum Temperature & Indoor Humidity Recording Function:
•
Press "MAX/MIN" button to show the maximum recorded Indoor / Outdoor Temperature and
Indoor Humidity. "MAX" is shown on the LCD.
•
Press "MAX/MIN" button again to show the minimum recorded Indoor/Outdoor Temperature
and Indoor Humidity. "MIN" is shown on the LCD.
•
When viewing maximum or minimum record, hold "MAX/MIN" button to clear minimum and
maximum temperature & humidity record.
(4) Outdoor Temperature Alert Function
•
Press "OUTDOOR TEMP ALERT" button to select to activate or deactivate outdoor
temperature alert function.
•
Press ALERT button select to:
- Active outdoor upper temperature alert, the icon "
would display.
- Active outdoor upper& lower temperature alert, the icon "
rature digit would display.
- Active outdoor lower temperature alert, the icon "
would display.
- Deactivate outdoor temperature alert, alert icon disappear.
•
Hold "OUTDOOR TEMP ALERT" button for 3 seconds to enter outdoor temperature alert
setting. Icon "
to adjust the setting value, press "OUTDOOR TEMP ALERT" to confirm the setting. Setting
sequence as follow: Upper limit of temperature, Lower limit of temperature.
When it's alert, the corresponding icon "
to stop the alert sound. .
(5) The use of 1.5 m cord Temperature Probe:
•
Insert the probe plug to the jack on the right hand side of the thermo sensor unit.
•
Put the cable outside and leave the thermo sensor unit in indoor area to avoid freezing
up the battery when the outdoor temperature is below -20 °C.
•
Always use the temperature probe to sense the temperature when the temperature
is between the following range: -50 °C ~ 0 °C and +50 °C ~ + 70 °C.
7. TIME AND ALARM SETTING
7.1 Radio Controlled Clock:
•
After power up and main unit finishes receiving the transmissions from outdoor thermo
sensor, the clock automatically starts to scan the DCF time signal. Radio Control Icon "
flashes on the LCD.
flashes,
Indicating now is receiving
DCF signal
•
The clock automatically scans the time signal at 3.00 a.m. every day to maintain accurate
timing. If reception fail, scanning stops ("
•
The clock can be set to scan the time signal manually by holding "-"button for 3 sec.
•
Stop scanning by holding "-" button for 3 seconds.
•
"DST" shown on the LCD if it is in Daylight Saving Time Mode.
" or "
" below outdoor temperature's digits flash. Press "+"or "-" button
turns on,
Indicating signal received
successfully
. If current humidity measurement is higher than
" below outdoor temperature digit
" below outdoor temperature digit
" or "
" would flash on the LCD. Press any buttons
" on LCD disappear).
ENG - 27
" below outdoor tempe-
disappear,
Indicating signal reception
failed
ENG
"