Introduction; Device Description (Fig. 1); Scope Of Delivery - Scheppach HF60 Original Bedienungsanleitung

1.

Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new tool brings you much enjoyment and
success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling
• Failure to comply with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts,
• Improper use
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
26 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.

2. Device description (Fig. 1)

1. Table width extension
1a. Left table extension
1b. Right table extension
2. Stop
2a. Stop bar
2b. Vertical stop support
2c. Moving stop
2d. Pressure bar
2e. Pressure bar holder
2f. Stop base
2g. Retaining device
2h. Horizontal stop support
2i. Fastening clamp
3. Work table
4. Clamping screw to define the working depth
5. Handle
6. Speed switch
7. On/off switch
8. Overload switch
9. Front pressure bar
9a. Front pressure bar holder with screws
10. Transverse cutting gauge
10a. Transverse cutting gauge locking nut
11. Mounting device for table width extensions
12. Suction adapter
13. Protective cover with alignment pin
14. Reduction piece
15. Tool receiver
16. Combination spanner SW18
17. Combination spanner SW24

3. Scope of delivery

• Tabletop milling machine
• Left table width extension (1a)
• Right table width extension (1b)
• 2x Stop bar (2a)
• 2x Retaining device (2g)
• 2x Vertical stop support (2b)
• 2x Fastening clamp (2i)
• Pressure bar (2d)
www.scheppach.com