SUPAIR ACCESS 2 BUMP Betriebshandbuch Seite 65

Harness User's manual | ACCESS 2 BUMP
CONNECTING THE WING TO THE HARNESS
Connecting the wing to the harness
Without twisting the risers, connect them to the harness attachment loops using the self-locking carabi-
ners.
Check for the risers to be properly positioned and untwisted. The «A» risers must be located at the front
and facing the flight direction (see diagram).
Lastly, check for the main self-locking carabiners to be fully closed and locked in place.
Installing the accelerator
« A » risers
Install the accelerator by following the instructions found on page 12.
Connect it to the wing using the split hooks.
Once the accelerator/speedbar is connected, adjust its length according
to your measurements. For correct use, there must not be any tension
at the split-hook level when the accelerator/speedbar line is fully
relaxed.
Self-locking
carabiner
Harness
Flight direction
ACCESS 2 BUMP | page 27