Operation - Klarstein MISTRAL Bedienungsanleitung

EN
30

OPERATION

Remote control
The function of some buttons on the remote control corresponds to the function
of the buttons on the control panel. Point the infrared transmitter of the remote
control at the receiver of the unit during use. Make sure that there are no
obstacles between the remote control and the unit. Remove the batteries from the
remote control if you will not be using it for a long period of time.
Operation
On / Off:
After plugging the mains plug into the socket, press this button or the
ON/OFF button on the remote control to start the unit or put it into
standby mode.
Wind speeds
Three speed levels are available. When the unit is switched on, press
this button to adjust the speed. Each press increases the speed (hold
down the button for faster adjustment). If you press the button again
when the highest speed level is reached, the appliance will start again
at the lowest speed level, etc.
Remote control:
When the unit is switched on, press the + or - buttons on the remote
control to adjust the speed to the highest or lowest fan speed (hold
down the button for faster adjustment).
Timer:
• Once the unit is switched on, press this button to set the time after
which the unit should go into standby mode (1-7 hours). Press
and hold the button for faster adjustment. When "7 h" is displayed
on the screen and you press the button again, the setting will be
cancelled.
• If you press the button in standby mode, you can set the time until
automatic switch-on (1-7 h; keep the button pressed for faster
adjustment). When "7 h" is displayed on the screen and you press
the button again, the setting will be cancelled.