Commissioning And Operation; Switching Appliance On/Off - Klarstein Skytower 360 Smart Bedienungsanleitung

EN

COMMISSIONING AND OPERATION

Before use
• Remove the appliance from its packaging and remove all packaging materials.
• Place the appliance on a stable and level surface.
• Insert the mains plug into the socket. The appliance can then be used directly and
no installation is required.
Commissioning
When the appliance's mains plug is plugged into the socket for the first time, the
appliance beeps twice and goes into standby mode. All indicator lights are off. Except
for the ON/OFF button, all buttons are inactive.

Switching appliance on/off

If you press the ON/OFF button in standby mode, the appliance is switched on.
When the appliance is switched on for the first time, the appliance runs at low speed
in normal wind mode. When the appliance has been switched off and you switch it on
again, the mode used before switching off is restored. This does not apply to the timer
setting. If the sleep wind mode was set before switching off, this is not saved. When the
appliance is switched on again, it will run in normal wind mode.
If no button (including remote control buttons) is pressed within one minute during
operation, all light indicators are dimmed to 30 % of their original brightness. Press the
desired button again to restore the brightness and perform the respective function.
To switch off the appliance, press the ON/OFF button again. The appliance will
beep once. When the appliance has been switched off, it goes into standby mode and
the light indicators and screen go out.
Swing function
In the power-on state, press the left-right swing button to switch on/off the left-right
swing function, and the corresponding LED indicator (2) will show its working state.
In the power-on state, press the up-down swing button to switch on/off the up-down
swing function, and the corresponding LED indicator (3) will show its working state.
The left-right swing mode works as follows: the swing head swings left and right at an
80° angle. When switching the direction, the swing head will pause for 1 second and
then swing to the other direction.
28