Weller WD 1 Betriebsanleitung Seite 36

14-18
I II III
I II III
I II III
All manuals and user guides at all-guides.com
Unlock the soldering station:
1. Select the menu item LOCK in Menu 1.
"ON" appears in the display. The padlock symbol is displayed.
2. Enter the 3-digit lock code with the UP or DOWN button.
3. Press the III button.
The station is now unlocked. The display switches to the main
menu.
Note The soldering station can also be unlocked using a decoder list or
the reset connector.
7.2 Selecting Menu 2 special functions
Special functions
ID
FCC
1. Press and hold down the UP and DOWN buttons simultaneously.
"– 2 –" appears in the display after 4 s.
2. Release the buttons.
Selection of the special functions of Menu 2 is activated.
The settings can now be made.
- Press the I and II buttons to select menu items.
- Press the III button to exit the menu again (EXIT).
Setting the station identification (ID code)
When the optional USB port is used, several
WD 1 (M) / WD 1000 (M) soldering stations can be activated and
remote-controlled to their full operational extent. To this end, each
station requires a station identification (ID code) so that it can clearly
identified.
1. Select the menu item REMOTE ID in Menu 2.
2. Enter an ID with the UP or DOWN button
(possible values 0 – 999).
3. Press the I (back) or II (forwards) button to switch to the next
menu item.
Note Press button III to exit the menu item without changes (EXIT).
WD 1 (M) / WD 1000 (M)
Navigation
↓
I
↑
II
EXIT III