Omron HEM-907 Gebrauchsanweisung Seite 17

1. Wrap the arm cuff over the
patient's arm.
3. Set the MODE Selector to
"AVG.".
5. Push the START Button to start
the measurement.
•
Set the unit to the start time of
the first measurement, then the
unit starts measurement auto-
matically.
•
After displaying the results of
first measurement, the unit will
measure blood pressure in the
set number of times automati-
cally by taking an interval.
•
For the setting of the number of
measurements, the waiting time
before start of measurement,
and the interval time, refer to
Page 7.
7. Push the ON/OFF (power)
Button to turn off the power.
How to Measure Blood Pressure
2. Push the ON/OFF (power)
Button to turn on the power.
4. Set the P-SET (pressure set-
ting) Volume to "AUTO" or the
ON/OFF
target inflation value.
•
START
HIDE
P-SET MODE
140 180 SINGLE
AVG. MANU.
220 CHECK
100
STOP
260
AUTO 280
•
6. Measured results are
displayed.
ON/OFF
•
START
HIDE
P-SET MODE •
SINGLE
140 180
AVG. MANU.
220 CHECK
100
STOP
260
280
AUTO
To stop the measurement during the measurement:
ON/OFF
Push the STOP Button.
To start the stopped measurement again:
START
HIDE
Push the START Button.
P-SET MODE
SINGLE
140 180
MANU.
AVG.
220 CHECK
100
STOP
260
AUTO 280
When setting the P-SET to
"AUTO", turn the Volume coun-
terclockwise as far as it goes
until you can hear the click
sound.
When the systolic pressure is
expected to exceed 220 mmHg,
proper inflation may not be pos-
sible in "AUTO" setting.
Set the target inflation value to
30 to 40 mmHg higher than the
expected systolic pressure.
After the measurement is
completed, average values are
displayed.
Each time a DEFLATION
(deflation control) Button is
pushed, the measurement
results for each time are
displayed.
(in AVG. Mode)
ON/OFF
START
HIDE
P-SET MODE
SINGLE
140 180
AVG. MANU.
220 CHECK
100
STOP
260
AUTO 280
ON/OFF
START
HIDE
P-SET MODE
SINGLE
140 180
AVG. MANU.
220
100 CHECK
STOP
260
AUTO 280
SYS
mmHg
DIA
mmHg
PULSE
BPM
HIDE
17