Eibenstock ESD 162 Originalbetriebsanleitung Seite 19

Additional Handle
Switching ON and OFF
Short-time operation
ON: Press the ON/OFF switch
OFF: Release the ON/OFF switch
Long-time operation
ON: Keeping the ON/Off switch pressed, push in the arrestor button.
OFF: Press and release the ON/OFF switch again.
Attention!
Use the arrestor button only during operation with drill rig.
!
Its use during manual operation is not allowed.
If the machine stops for any reason or due to power failure,
immediately release the arrestor button by pressing the
ON/OFF switch.
Dust Exhaustion
For manual drilling, the ESD 162 may be used
only together with its additional handle which
comes with the tools.
Place it on the gearing collar from the front and
fix it by turning the handle in direction of the
arrow.
Before mounting or dismounting the handle
clamp, the dust exhaustion must be
disconnected from the gearing collar.
Dust which occurs
hazardous to health. That is why it is advisable
to use a deduster (Dust class M) and to wear a
dust mask on dry drilling. Place the adapter for
the dedusting unit onto the tool's connector and
turn into the direction of the arrow up to the stop.
As a suitable wet/dry deduster, our DSS 35 M iP
is available as add-on. The use of a dedusting
system is also a prerequisite for optimal cutting
performance of the bit (air cooling).
18
during your work is