Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation instructions
1. Infrared light
2. Camera image sensor
3. Adjusting screw
4. Bracket
5. Screw hole
6. Audio switch
1. Open the rubber cover to expose the channel select switches.
2. Use tweezers or a sharp tool to select the switching position, according to the desired channel.
The receiver and the camera must be on exactly the same channel.
On the rear of the camera you can see how to position the switches inside of the
camera.
3. Close the rubber cover.
4. Fit the camera unit with the support with 3 screws on a horizontal or vertical surface.
5. Loosen the adjusting screw (3).
6. Rotate the camera to the desired position.
7. Tighten the adjusting screw.
8. Connect the AC/DC adapter with the camera's power input plug.
9. Turn the microphone on or off with the audio switch (6) on the plug.
7.
Microphone
8.
Power input plug
9.
Rubber cover
10. Channel select switches
11. Flat transmitting antenna
5
Werbung
Inhaltsverzeichnis
Fehlerbehebung
