Installation Instructions; Maintenance; Troubleshooting - Konig Electronic SEC-CAM12 Bedienungsanleitung

Installation instructions

1. Infrared light
2. Camera image sensor
3. Adjusting screw
4. Bracket
1. Fit the camera with the support using 3 screws on a horizontal or vertical surface.
2. Loosen the adjusting screw (3).
3. Rotate the camera to the desired position.
4. Tighten the adjusting screw.
5. Insert the cable plugs into the jack connectors; black into black, yellow into yellow, white into white.
6. Connect the AC/DC adapter with the black connector near the monitor.
If you use the SEC-MON51 monitor, the camera will be powered through the monitor.
To connect to the monitor, refer to the SEC-MON51 monitor's installation and user
manual.

Maintenance

Clean the camera with a damp cloth.
Do not use cleaning solvents or abrasives.

Troubleshooting

Carry out the following checks if the camera is not working properly:
• Make sure that all of the plugs are correctly fitted into the jack connectors.
• Make sure that the camera is not damaged.
• Make sure that the power adapter is not damaged.
5. Screw hole
6. Audio switch
7. Power input
8. Microphone
4