Husqvarna Soff-Cut 2000 Bedienungsanweisung Seite 60

6. Pull the dipstick out and examine the oil level.
7. If the oil level is low, fill with engine oil and do a
check of the oil level again. Refer to
on page 70 for correct oil type.
8. Tighten the oil tank cap correctly before you start the
engine.
Note:
The engine has a system that stops the engine
if the oil level is too low. The engine cannot be started
unless the oil level is above the specified limit.
To examine the hydraulic oil level
1. Stop the engine.
2. Make sure that the engine is cold.
3. Put the product on level ground.
4. Make sure that the level of hydraulic oil is
immediately above the tight part of the hydraulic oil
container.
5. If the hydraulic oil level is below the tight part of the
hydraulic oil container:
a) Clean the hydraulic oil container to decrease the
risk of contamination of hydraulic fluid when the
container is open.
b) Remove the cap for the hydraulic oil container.
c) Fill with hydraulic oil to immediately above the
tight part of the hydraulic oil container. Refer to
Technical data on page 70 for correct oil type.
6. Tighten the cap for the hydraulic oil container
correctly before you start the engine.
60
To replace the engine oil
1. Put a container below the drain plug for the engine
2. Remove the drain plug.
3. Let the oil run out into the container.
Technical data
4. Attach the drain plug and tighten it.
5. Remove the oil tank cap and the attached dipstick.
6. Fill with new oil. Refer to
To replace the air filter
Note:
for more information about the air filter.
1. Remove the air filter cover (A).
WARNING:
directly after the engine stops. Let the
engine become cool before you drain the
engine oil. If you spill engine oil on your skin,
clean with soap and water.
oil.
70 .
CAUTION:
cleaned. Replace dirty or worn air filters.
Refer to the operator's manual for the engine
Engine oil is very hot
Technical data on page
The air filter cannot be
793 - 001 - 19.04.2022