Husqvarna Soff-Cut 2000 Bedienungsanweisung Seite 51

Note:
If a metal noise occurs, operate the engine
for 5 minutes. If the noise continues, operate the
engine at middle throttle for 20 minutes. If the noise
continues, speak to your Husqvarna service agent.
5. Set the choke function to OFF.
a) If the engine is cold, move the choke lever slowly
to the right, to set the choke function to OFF.
b) If the engine is warm, move the choke lever
immediately to the right, to ser the choke function
to OFF.
6. Pull the throttle control out ⅓.
To do work with dust
This product has a dust outlet on the blade block cover.
The dust outlet is used to connect a dust extractor.
• Always use a dust extractor. It is also recommended
to use an antistatic extraction hose.
Note:
For Husqvarna products, OSHA objective
data are available at www.husqvarnacp.com/us. The
performance of the dust extractor can change over
time.
To connect a dust extractor to the
product
1. Turn the wing nut on the plug counterclockwise.
2. Remove the plug from the pipe on the blade block
cover.
793 - 001 - 19.04.2022
3. Connect a dust extractor to the blade block. Turn the
screw to attach it.
Note:
If the dust extractor is not compatible with
the connection on the product, use an adapter.
To operate the product
1. Start the engine. Refer to
page 50 .
2. Push the front pointer lever to "DOWN". The front
pointer is fully lowered.
To start the engine on
51