Husqvarna Soff-Cut 4000 Bedienungsanweisung Seite 57

Maintenance
Examine the drive belt and replace if dam-
aged.
Replace the oil .
Lubricate the blade shaft bearings.
Replace the air filter.
Examine the fuel tank cap
Examine the spark plug and electrode gap
Replace the fuel filter
To examine the spark plug
CAUTION:
recommended spark plug type. Incorrect
spark plug type can cause damage to the
product.
• For more information, refer to the operator's manual
for the engine.
To clean the product externally
CAUTION:
immediately after use, before the concrete
becomes dry. Remaining concrete can
cause damage to the product.
1. Remove the blade. Refer to
blade on page 58 .
2. Clean the product with water.
CAUTION:
directly at the engine, especially if you
use a high-pressure washer.
3. Make sure that the handles and levers are clean and
dry before you operate the product.
794 - 001 - 19.04.2022
Every
use
Always use the
Always clean the product
To remove the cutting
Do not point the water
Weekly Monthly
Daily
(50 h)
X
X
4. Clean the blade block and blade from concrete
particles after each use. Use a heavy duty brush and
water. The remaining concrete (A) will dry and set
(B) if you do not remove it.
A B
5. Keep all openings and slots on the product clean
to make sure that air flows freely through the motor
area.
To do a general inspection
• Make sure that the nuts and screws on the product
are tightened.
• Make sure that there are no fuel or oil leaks.
Annually After the
first 20 h,
then
(200 h)
each 100
h
X
X
X
X
X
57