Husqvarna Soff-Cut 4000 Bedienungsanweisung Seite 51

CAUTION:
contains methanol.
CAUTION:
30 days in a container. Expired fuel can
cause damage to the product.
1. Remove the product from the transportation vehicle
and put it on the ground. If this is not possible, refuel
the product with a portable container and not from a
gasoline pump nozzle.
WARNING:
gasoline containers.
2. Open the fuel tank cap slowly to release the
pressure.
3. Make sure that the nozzle touches the top edge of
the fuel tank opening until the fuel tank is full. Do not
use a nozzle lock-open device.
4. Clean the area around the fuel tank cap.
5. Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
6. Move the product a minimum of 3 m/10 ft from the
position where you filled the tank before a start.
To start the engine
CAUTION:
can be started with the forward drive
engaged. Make sure the forward speed
lever is in "STOP" position before the engine
is started.
1. Pull the forward speed lever to "STOP".
2. Make sure that the cutting height position is up.
794 - 001 - 19.04.2022
Do not use gasoline that
Do not keep fuel more than
Use only approved
The engine on this product
3. Turn the fuel valve clockwise to open the fuel valve.
4. Put the throttle control between slow and fast
positions.
5. Move the choke lever to the left to set the choke
function to ON.
6. Turn the ignition key to "START" and release when
the engine starts.
CAUTION:
continuously for more than 10 seconds.
Wait 60 seconds to let the engine
become cool before restart.
Note:
If the engine does not start, turn the ignition
key to "STOP". Speak to your Husqvarna service
agent.
Do not crank the engine
51