Husqvarna Soff-Cut 4000 Bedienungsanweisung Seite 67

Problem
The product causes chip-
ping/ spalling or ravelling in
the cut .
The product pulls to one
side while sawing.
794 - 001 - 19.04.2022
Solution
Make sure that the cutting blade is not worn out, smooth, out of shape or damaged.
Make sure that the skid plate does not touch the cutting blade and moves freely up
and down the full shaft length.
Make sure that the skid plate is not worn out and that there is no distance around the
cutting blade.
Examine the bottom of the skid plate and make sure that there are no metal burrs or
defects.
Make sure that the skid plate is not twisted or bent.
Make sure that the blade block guards move freely up and down.
Make sure that each end of the skid plate has a pressure down.
Do not twist or move the product sideways while cutting. Make gradually changes in
pressure on the handlebar to control the saw in the cut.
Make sure that the engine operates correctly and at the specified rpm.
Examine the belt and the pulleys for correct tension.
Make sure that the blade is correctly assembled and attached with clean flanges.
Make sure that the cutting blade has the correct specification for your area or type of
concrete.
Make sure that the concrete surface is clean and that the skid plate can move smooth-
ly along on the concrete surface.
Use Husqvarna joint guards at all cut intersections.
Clean unwanted concrete contamination from the blade block assembly.
Make sure that the scrapers in the blade block can move freely and that they are not
bent.
Make sure that the blade block shafts are not bent or damaged.
Do a check that the front pointer is correctly aligned with the center of the cutting
blade.
Do a check of the skid plate for damage or burrs.
67