Personal Protective Equipment; Before Use - Hilti DCG 230-D Bedienungsanleitung

5.7.5 Personal protective equipment

The user and any other persons in the vicinity must
wear suitable eye protection, a hard hat, ear protec-

6 Before use

WARNING
Never use the power tool without the guard.
6.1 Fitting the side handle
WARNING
The side handle must be fitted for all types of work.
The side handle may be screwed onto the power tool on
the right or left.
6.2 Fitting and removing the guard 3
NOTE
The clamping ring at the spindle collar has already been
adjusted to the correct clamping diameter by way of the
adjusting screw. If the tension is too low when the guard
is fitted, the adjusting nut can be tightened slightly to
increase the tension.
The guard is equipped with a segmented locating ring. In
order to ensure that only the correct guard can be fitted,
the shortest of the eight segments on the ring features a
keyed locating lug. The keyed locating lug also prevents
the guard from coming into contact with the disc.
1. Disconnect the supply cord plug from the power
outlet.
2. Release the clamping lever.
3. Press the guard onto the drive spindle collar.
4. Position the guard with its segmented locating ring
in the guide on the spindle collar in such a way that
the segment with the keyed locating lug can engage
in the groove on the spindle collar.
5. Rotate the guard to the required position.
6. CAUTION The closed side of the guard must
always face the operator.
Secure the guard by closing the clamping lever.
All manuals and user guides at all-guides.com
tion, protective gloves and breathing protection while
the power tool is in use.
6.3 Adjusting the guard 4
1.
2.
3.
4.
6.4 Fitting the cutting / grinding disc 5
DANGER
Check that the speed rating printed on the cutting
or grinding disc is equal to or higher than the rated
speed of the power tool.
DANGER
Check the condition of the grinding disc before us-
ing it. Do not use discs that are broken, cracked or
damaged in any way.
1.
2.
3.
4.
5.
6.
7.
6.5 Using the Kwik-Lock clamping nut with
CAUTION
When operating the power tool, take care to ensure
that the Kwik-Lock nut does not come into contact
Disconnect the supply cord plug from the power
outlet.
Release the clamping lever.
Rotate the guard to the desired position.
Close the clamping lever.
Disconnect the supply cord plug from the power
outlet.
Clean the clamping flange.
CAUTION The clamping flange is equipped with
an O-ring. If this O-ring is missing, the clamping
flange must be replaced.
Fit the clamping flange onto the drive spindle.
Fit the diamond disc, cutting disc or grinding disc.
Screw on the clamping nut and tighten it.
CAUTION Do not press the spindle lockbutton
before the drive spindle has stopped rotating.
Press the spindle lockbutton and hold it in this
position.
Use the wrench to tighten the clamping nut securely
and then release the spindle lockbutton.
grinding / cutting discs
en
25