Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Before getting started
• Read chapter "Safety" from page EN-4 and
all the safety notices.
• Set up and connect the appliance as de-
scribed in chapter "Set-up" from page EN-22.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
■ Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting.
Switching on
The appliance is switched on as soon as the
mains plug is plugged in.
The compressor starts to work, the refrigerant
flows through the pipes and a quiet humming
sound can be heard.
The symbols on the control panel illuminate
for 3 seconds.
If the appliance makes unusual noises,
check that it is on a solid base and re-
move any objects that are on top of the
appliance.
Switching off
• To switch the appliance off, pull the mains
plug out of the socket.
If the appliance is switched off, leave
the appliance door (2) open slightly to
avoid mould formation.
Operation
Setting the temperature
CAUTION
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. The
temperature may increase in the fridge
which may cause the foods stored with-
in to spoil more quickly.
■ Always ensure the prescribed ambi-
ent temperature is maintained (see
"Intended use" on page EN-4).
If you set a lower temperature, you will
need higher cooling performance. This
increases the energy consumption.
Switching on for the first time
The standard temperature setting for when
the appliance is first switched on is +5°C.
All symbols on the display will also illuminate
for a couple of seconds; the control panel is
locked.
Locking/unlocking the control
panel
• To unlock the control panel, press the but-
ton (19) for 3 seconds. The "Button lock
active" indicator (15) will disappear, a beep
will sound and the control panel will unlock.
• To lock the control panel, press the but-
ton (19) for 3 seconds. The "Button lock
active" indicator (15) will appear, a beep
will sound and the control panel will lock.
Page EN-13
Werbung
Inhaltsverzeichnis
