Features Of The Device (Fig. 1) - eta Fenite Bedienungsanleitung

GB
– Do not overfill the container, the maximum amount of water is 7.5 ml.
– Don't scrape the transducer with hard objects.
– Also, do not put the hair straightener on soft and easily flammable surfaces
(e.g. bed, towels, sheets, carpets); they could be damaged by hot parts of the
appliance.
– When handling the hair straightener, protect the power cord from contact with the
hot surface of the plates or other sources of heat.
– Switch off the hair straighteners right after its use, unplug it from power supply and
let it cool down. Then put it on a safe dry place, out of reach of children.
– Check the condition of the power cord of the appliance regularly.
– Do not wind the power cord around the appliance; this will extend life of the power
cord.
– The power cord must not be damaged with sharp or hot objects, open fire, it must
not be sunk into water or bent over sharp edges.
– If you need to use an extension cord, it has to be uncorrupted and it has to comply
with the valid standards.
– Never use the appliance for any other purpose than for that described in these
instructions for use!
– WARNING: There is a risk of injury in case of incorrect use (not in accordance with
the manual) of the appliance.
– All text in other languages and pictures shown on the packaging, or the product
itself, are translated and explained at the end of this language mutation
– The manufacturer is not responsible for damage caused by improper handling of
the appliance (e.g. fire, burning, hair damage, etc.) and its guarantee does not
cover the appliance in the case of failure to comply with the safety warnings above.
II. FEATURES OF THE DEVICE (FIG. 1)
A – hair straightener
A1 – ON / OFF switch
A2 – temperature regulator +/-
A3 – steam ON / OFF switch
A4 – control lights light signaling
B – water container
B1 – ultrasound converter
B3 – cap
C – case
The hair straightener creates microscopic drops of water with the diameter of
about 1 – 5 μm using high-frequency oscillator. The ventilation system then
blows them out in the form of vapour (fog) into the heating plates where they
evaporate and thus increase air humidity hairstyles.
A5 – heating plates
A6 – turning joint of power cord
A7 – water container locking button
A8 – power cord
A9 – slider control of jaw lock
B2 – water steam escape opening
Note
18 / 42