ASSEMBLY INSTRUCTIONS
Step 1:
1. Remove the unit from the box and put it on a flat and level floor.
2. Unwind wiring harness and run wires up through CONSOLE MAST (9). Bolt CONSOLE MAST (9)
to MAIN FRAME (1) using 4 BOLTS (54), 4 LOCK WASHERS (57), and 4 WASHERS (65). Pay
attention not to squeeze any cables!
3. Run wires from CENTER HANDLEBARS (11) through HANDLEBAR BRACKET (10), into
CONSOLE MAST (9) and out the top.
4. Install CENTER HANDLEBARS (11) to HANDLEBAR BRACKET (10) using 4 BOLTS (52) and
then the HANDLEBAR BRACKET (10) to CONSOLE MAST (9) using 4 BOLTS (54).
5. Attach CUP HOLDER (99) to HANDLEBAR BRACKET (10) using 2 SELF-TAPPING SCREWS
(46) and 2 WASHERS (58).
35