Using The Heater; Overheat Protection - HOMCOM 820-249V70 Montageanleitung

25. The use of attachments or accessories not recommended or sold by the product
distributor may cause personal or property hazards or injuries.
26. This product is intended for normal domestic/household use only.
Use this heater as described in this manual. Any other uses, not recommended by the
manufacturer, may cause fire, electric shock, or injury to persons and may void the
warranty.

USING THE HEATER

1. Before inserting the plug into an electrical outlet, make sure that the electrical supply in
your area matches that on the rating label on the unit.
2. When plugged in, turn on the Main power switch at the base side of unit.
3. When in Standby mode, only
to access the rest of the control panel.
a) Low Power: (Press
b) High Power: (Press
c) Timer: Press
(between 0 hour to 8 hours)
d) + , - : adjust room temperature .Temperature setting from 10-49 degree. "+" to increase
the desired temperature and "-" to decrease the desired temperature
e) Swing : Press
f) , turn on or turn off item . item always keep working 30 seconds of cool air after turn
off it . this design can protect item use longer.
Warning:
1. Before removing the plug from the socket, switching off and better work for 30-60
second for cool down in condition that protecting inner parts.
Remote control
Please use Lithium battery CR2025 3V.NOTE: the remote control buttons perform the same
functions as those on the control panel on the unit.

OVERHEAT PROTECTION

This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat,e.g. due to the total or partial obstruction of the grids. In
this case, unplug the appliance, wait about 30 minutes for it to cool and remove the object
which is obstructing the grids. Then switch it back on as decribed above. The appliance
should operate normally. Should the problem persist, please contact the nearest customer
service.
on the control panel will respond to your touch. Press
to switch it)
to switch it)
repeatedly to set a period after which the heater will turn itself off
to activate oscillation. Press it again to cancel.
3
EN