Electrical Connection - Balluff BAE-SA-OH-060-YI-S75G Montageanleitung

BAE SA-OH-060-YI-S75G
Photoelectric Sensors
Installation
The following mounting types of the sensor amplifiers are
available:
– Simple clamp mounting on DIN rail with dimension of
DIN 35 mm or 15 mm.
– Screw mounting by means of through holes for M3
screws.
– Clamp mounting on DIN rail adapter by means of M3
threaded screws.
Place the device on the DIN rail adapter as shown. Connect
the cable according to the connection table.
Fig. 2: Mounting the amplifier

Electrical connection

2 4
1 1
3
4-pin (supply)
Connection Pin
1 VDC
4-pin
2 I/Q
(supply)
3 GND
4 C/Q
1 LED+
3-pin
3 FT+
(sensor)
4 GND
Factory setting
– Mode: SIO mode
– Operating mode: Standard Power, Standard
Sensor
– PIN 4: PNP switch output
(in IO-Link mode: Push-Pull)
– PIN 2: Inactive (PNP)
www.balluff.com
4
3
3-pin (sensor)
Signal
L+ (operating voltage+
SIO 15...30V,
IO-Link 18...30V)
Max. current consumption:
45mA
Digital input /
Digital output
L- (operating voltage- 0V)
IO-Link communication /
Digital output in SIO mode
Transmitter (LED)
Receiver (phototransistor)
0V / cable shield
Shielding and cable routing
The sensor cable is shielded and should not be extended.
For IO-Link operation, the maximum supply cable length is
20 m.
english 3