Tension Adjustment - Labelmate RRC-330-STATIONS Bedienungsanleitung

OPERATING THE RRC-UNIT STEP 2
• Place an empty label Core (not included) over the Take-Up Spindle FIG.1.3 and secure the Label Web using a piece of
tape.
• Enter the desired Label Count via the Push Buttons on the Counter. If you do not use preset, set the value to "0".
• The machine will stop when out of paper. To re-start, load paper, and set the Stop/Run Switch to STOP. Re-set the
counter if necessary. Start by switching to "RUN".
• It is recommended to use the machine at its maximum speed.
• Keep unwind plate clean of particles and glue.

TENSION ADJUSTMENT

• The web tension is adjustable via the red knob on the unwinding shaft. FIG.1.5 This knob can be replaced with a regu-
lar M5 screw so the adjustment can only be made with a wrench, in order to prevent the operator to change the brake
setting.
LEFT SIDE CONTROL PANEL:
• RESET: The new left-side control panel has three items. The toggle switch (reset) is a momentary closing switch, that
has the same function as the reset button on the counter, but is more convenient for the operator.
• ADJUST: Potentiometer.
• TEST: Green LED
USING THE ADJUSTABLE CORE HOLDER (ACH-MODELS)
• Loosen the three (3) Lock Levers on the back of the ACH Flange Plate.FIG.2.1
• Grasp the front Flange Plate with one hand and the rear Flange Plate with the other.
• Rotate the Plates in opposite directions until the three (3) Core Fingers move to the centre of the ACH next to each other.
• Slide an empty cardboard core only partway (about 50mm / 2") over the Fingers.
• Now rotate the Flange plates in opposite directions to expand the Fingers against the inside of the cardboard core.
While you hold the Flanges so the Fingers are against the inside of the core, rotate one of the Locking Levers clockwise
until it is snug. DO NOT OVER TIGHTEN.
• Move the other two (2) Locking Levers to the LOCK position. DO NOT OVER TIGHTEN.
• Now slide the core all the way on up against the inside Flange. If the core is too tight, loosen the Lock Levers and try
again sliding the core a little further over the Fingers to yield less tightness.
Labelmate.com