Bosch PCM 7 S Originalbetriebsanleitung Seite 34

OBJ_BUCH-1270-001.book Page 34 Thursday, July 22, 2010 12:44 PM
34 | English
Mounting the Saw Blade
If required, clean all parts to be mounted prior
to assembly.
– Press lever 3, swing back the retracting
blade guard 5 to the stop and hold it in this
position.
– Place the new saw blade onto the interior
clamping flange 35.
When mounting the saw blade, pay atten-
tion that the cutting direction of the teeth
(arrow direction on the saw blade) corre-
sponds with the direction of the arrow on
the blade guard!
– Slowly guide the retracting blade guard
downward again.
– Place on the clamping flange 34 and the
screw 33.
Press the spindle lock 30 until it engages and
tighten the screw turning in anticlockwise di-
rection.
Operation
Before any work on the machine itself, pull
the mains plug.
Transport Safety (see figure F)
The transport safety-lock 29 enables easier han-
dling of the machine when transporting to vari-
ous working locations.
Releasing the Machine (Working Position)
– Push the tool arm by the handle 1 down a lit-
tle in order to relieve the transport safety-
lock 29.
– Pull the transport safety-lock 29 completely
outward.
– Guide the tool arm slowly upward.
Securing the Machine (Transport Position)
– Loosen the locking screw 26 if tightened.
Pull the tool arm completely to the front and
tighten the locking screw again.
– Screw the depth stop 18 completely to the
top. (see "Adjusting the Depth Stop",
page 36)
1 609 929 W43 | (22/7/10)
– To lock the saw table 8, tighten the locking
knob 9.
– Press lever 3 and at the same time, swing the
tool arm by handle 1 toward the rear until the
transport safety-lock 29 can be pushed com-
pletely inward.
The tool arm is now securely locked for trans-
port.
Clamping the Workpiece (see figure G)
To ensure optimum working safety, the work-
piece must always be firmly clamped.
Do not saw workpieces that are too small to
clamp.
– Press the workpiece firmly against the
fence 15.
– Insert the material clamp 16 provided into
one of the holes 23 intended for it.
– Loosen the wing bolt 37 and adapt the mate-
rial clamp to the workpiece. Tighten the wing
bolt again.
– Firmly clamp the workpiece by turning the
threaded rod 38 in clockwise direction.
Loosening the Workpiece
– To release the material clamp, turn the
threaded rod 38 in anticlockwise direction.
Extending the Saw Table (see figure H)
Long workpieces must be underlaid or support-
ed at their free end.
The flexible saw-table extension plug-in system
14 enables a variety of extension possibilities.
– Insert the saw-table extension 14 into the
openings 28 of the saw-table base or into the
openings 32 of the second saw-table exten-
sion.
Bosch Power Tools