Installation Variants; Installation And Connection - Oase AquaMax Eco Classic 2500E Inbetriebnahme

Installation variants

 A
• Variant (a): Submerged installation of the pump
– The pump is positioned in the pond.
– Water is drawn in via the filter cage (pond bottom filtration).
• Variant (b): Dry installation of the pump
– The pump is installed without a filter cage outside the pond but lower than the water level.
– Water is drawn in via a satellite filter or skimmer.

Installation and connection

The pump can be installed submerged (in water) or dry (outside the water).
The use of the pump is only permitted subject to adherence to the specified water quality.
WARNING
Severe injuries or death from operation of the unit in a swimming pond. Faulty electric compo-
nents will apply dangerous electric voltage to the water.
 Never operate the unit in a swimming pond.
CAUTION
Rotating components in the area of the intake connection and the pressure connection. Reach-
ing into the connections can lead to injuries.
Please note in particular: If a unit has stopped due to overload, it can start up unexpectedly!
Do not reach into the opening of the inlet connection or outlet connection while the power

plug is connected.
 If the connections are freely accessible, e.g. if no hoses are connected, secure the connections
with a finger guard. The finger guard is available as an accessory.
NOTE
If the pump is used for conveying excessively muddy water, the impeller unit will be subject to
increased wear and will require earlier replacement.
 Thoroughly clean the pond or pool before installing the pump.
Install the pump at a raised level above the bottom of the pond. This reduces intake of muddy

water.

Avoid direct sunlight when the components of the unit are not immersed, as this can cause
them to heat up considerably. Use a protective cover if necessary.
EN
11