Specifications; Additional Safety Rules - Makita HM1400 Betriebsanleitung

ENGLISH
1 Bolts
2 Grip
3 Notched portion
4 Tool retainer

SPECIFICATIONS

Model
Blows per minute ....................................................................................... 1,200
Overall length ............................................................................................ 613 mm
Net weight ................................................................................................. 17 kg
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
be operated on single-phase AC/DC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.

ADDITIONAL SAFETY RULES

1. Wear a hard hat (safety helmet), safety glasses
and/or face shield. It is also highly recom-
mended that you wear a dust mask, ear protec-
tors and thickly padded gloves.
2. Be sure the bit is secured in place before opera-
tion.
3. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
4. In cold weather or when the tool has not been
used for a long time, let the tool warm up for sev-
eral minutes by operating it under no load. This
will loosen up the lubrication. Without proper
warm-up, hammering operation is difficult.
5. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
6. Hold the tool firmly with both hands.
7. Keep hands away from moving parts.
8. Do not leave the tool running. Operate the tool
only when hand-held.
9. Do not point the tool at any one in the area when
operating. The bit could fly out and injure some-
one seriously.
10. When chipping into walls, floors or wherever
"live" electrical wires may be encountered, DO
NOT TOUCH ANY METAL PARTS OF THE TOOL!
Hold the tool by the insulated grasping surfaces
to prevent electric shock if you chip into a "live"
wire.
4
Explanation of general view
5 Switch lever
6 Handle
7 Holder cap plate
8 Screwdriver
11. Do not touch the bit or parts close to the bit
SAVE THESE INSTRUCTIONS.
OPERATING INSTRUCTIONS
Installing grip (Fig. 1)
Install the grip securely with the bolts using the hex
wrench.
Installing or removing bull point or other bits
(cold chisel, etc.) (Fig. 2 & 3)
Important:
Always be sure that the tool is switched off and
unplugged before installing or removing the bit.
Turn up the tool retainer. With the notched portion of the
bit facing the tool retainer, insert the bit into the tool bar-
rel as far as it will go.
Return the tool retainer to its original position to secure
the bit.
To remove the bit, follow the installation procedure in
reverse.
Switch action (Fig. 4)
CAUTION:
• Before plugging in the tool, always check to see that
the switch lever actuates properly and returns to the
"OFF" position when released.
• Do not tape, tie or otherwise secure the switch lever in
the "ON" position.
To start the tool, simply squeeze the switch lever.
Release the switch lever to stop.
Chipping / Scaling / Demolition
Hold the tool firmly with both hands. Turn the tool on and
apply slight pressure on the tool so that the tool will not
bounce around, uncontrolled. Pressing very hard on the
tool will not increase the efficiency.
9 Brush holder cap
10 Plate 50
11 Hammer grease
HM1400
immediately after operation; they may be
extremely hot and could burn your skin.
HM1400K
1,200
600 mm
17 kg