Moving method
Handle - Two handles are designed on both
ends of the middle cover. When moving the
Product, lif t the end opposite of the castor,
grasp the handle and move the Product to the
desired place.
Storage
Befo re clean in g, en sure the power switch is turned o ff, and th e attaching p lug is p ulled out o f the so cket. Th e rubber ped al and covers
can be clean ed with a wet cloth containin g detergent, and the deterg en t should be removed with a cloth.
NOTICE : Do n o t clean th e product with corrosive detergent such as benzene o r thinner, as it may cause fading, corrosion or crack on the
!
Product. Do not splash water into the product to avoid short circuit.
CONTROLLE R
As wet cloth may cause malfunction of the controller, only dry cloth can be used.
Storage and maintenance
Make sure that the power switch is turned off and the plug is removed from the power supply
Clean off the dust and dirt on the Product and keep it clean and away from places with high temperatueę or high humidity.
If the Product is not in use for a long period, a dustproof cover (but it yorself) should be applied on the Pro- duct to prevent the entry
of dust.
Common problems & Solutions
1. Emerg en cy stop : Led o n co nsole shows '' Er-3", Led o n PCB flashes three Times.
2. Co n n ectio n error: Led o n co nsole shows ''ER-4", Led o n PCB flash es four Times.
3. Electron power tube demage: Led on console shows ''ER-5", Led on PCB flashes five Times.
4. Current Overload: Led on console shows ''ER-6", Led on PCB flashes six Times.
5. Engineer abnormality: Led on console shows ''ER-7", Led on PCB flashes seven Times.
6. Blocked Engineer: Led on console shows ''ER-8", Led on PCB flashes eight Times.
7. Low voltage: Led on console shows „ER-9", Led on PCB flashes nine Times.
Technical specyfication
Rated voltage: 220 – 240 V
Rated power: 240 W
Rated frequency: 50/60 Hz
Maximum user weight: 150 kg
Assembled size: 76 x 48 x 15 cm
G.W. / N.W.: 17/ 15,5 kg
Massage mat