Moving method
Handle - Two handles are designed on both
ends of the middle cover. When moving the
Product, lif t the end opposite of the castor, grasp
the handle and move the Product to the desired
place.
Storage
Befo re cleaning , ensure the power switch is turn ed off, and th e attaching p lug is pulled o ut o f the so cket. The rubber p ed al an d
co vers can be clean ed with a wet cloth co ntaining detergent, an d the detergen t sh ould be removed with a cloth.
NOTICE : Do n o t clean the product with corrosive detergent such as ben zene o r thinner, as it may cause fading, corrosion or crack on the
!
Product. Do not splash water into the product to avoid short circuit.
CONTROLLE R
As wet cloth may cause malfunction of the controller, only dry cloth can be used.
Storage and maintenance
Make sure that the power switch is turned off and the plug is removed from the power supply
Clean off the dust and dirt on the Product and keep it clean and away from places with high temperatueę or high humidity.
If the Product is not in use for a long period, a dustproof cover (but it yorself) should be applied on the Pro- duct to prevent the
entry of dust.
Common problems & Solutions
1. Emergen cy stop: Led o n con sole sh ows '' Er-3", Led o n PCB flashes th ree Times.
2. Co nnection error: Led o n co nsole sho ws ''ER-4", Led o n PCB flashes fo ur Times.
3. Electron power tube demage: Led on console shows ''ER-5", Led on PCB flashes five Times.
4. Current Overload: Led on console shows ''ER-6", Led on PCB flashes six Times.
5. Engineer abnormality: Led on console shows ''ER-7", Led on PCB flashes seven Times.
6. Blocked Engineer: Led on console shows ''ER-8", Led on PCB flashes eight Times.
7. Low voltage: Led on console shows „ER-9", Led on PCB flashes nine Times.
Technical specyfication
Rated vo ltage: 220 – 240 V
Rated p o wer: 240 W
Rated freq uency: 50/60 Hz
Maximum user weight: 150 kg
Assembly size: 69 x 39 x 13 cm
G.W./N.W.: 14,5/12,5 kg
Fun ctio n al massage with magnetic balls