Placing Tool In Service - Ingersoll-Rand LA413-EU Serie Bedienungsanleitung

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll–Rand No. 50
Always use an air line lubricator with this tool. We
recommend the following Filter–Lubricator–Regulator
Unit:
C28–C4–FKG0
After each eight hours of operation, unless an air–line
lubricator is used, inject 1/2 cc of Ingersoll–Rand No. 50
Oil into (1) before attaching the hose.
Model
LA413–EU
H
Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested in accordance to ISO8662–1 at free speed
•
ISO3744
All manuals and user guides at all-guides.com
WARNING LABEL IDENTIFICATION
90 psig
(6.2bar/620 kPa)

PLACING TOOL IN SERVICE

Ingersoll–Rand No. 67
SPECIFICATIONS
Type of
Handle Speed
Lever 1 800
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
TO MAIN LINES 3 TIMES
AIR AIR TOOL INLET SIZE
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
H Sound Level
Free
Pressure
88.5
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
dB (A) Level
•Power
101.5
2
m/s
1.1