Inhaltsverzeichnis
Werbung
GB
INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
• Please read the instruction manual before use and
save it for future references.
• Before the first switching on check that voltage
indicated on the rating label corresponds to the
mains voltage in your home.
• For home use only. Do not use for industrial
purposes. Use the steam iron only for its intended
use.
• Do not use outdoors or in damp area.
• Do not immerse the steam iron and cord in water or
other liquids.
• Never pull the cord while disconnecting from the
power outlet; instead, grasp the plug only and pull
to disconnect.
• Do not allow the cord to touch sharp edges and hot
surfaces.
• Always unplug the steam iron from the power
supply when filling with water or emptying and
when not in use.
• Do not operate the steam iron with damaged cord
or plug, or after the appliance malfunctions, or has
been dropped or damaged in any manner. To avoid
risk of electric shock, do not disassemble the
steam iron; take it to a service center for
examination, repair or mechanical adjustment.
• This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of the
appliances by a person responsible for their safety.
• Children should be supervised to ensure that they
do not play with the appliance.
• Do not leave the iron unattended while hot or
connected or on an ironing board.
• If ironing is interrupted, stand the iron on heel rest
only, do not place the steam iron on metal or rough
surfaces.
CAUTION: To avoid a circuit overload, do not operate
another high wattage appliance on the same circuit.
BEFORE THE FIRST USE
• Some parts of the steam iron have been slightly
greased and as a result the iron may slightly smoke
when switched on for the first time. After a short
time this will cease.
• Remove protection cover from the soleplate and
clean it with a soft cloth.
HOW TO USE
SETTING TEMPERATURE
• Always check whether a label with ironing
instructions is attached to an article to be ironed.
Follow these instructions in all cases.
• Turn the temperature control dial round to set the
appropriate temperature indicated in ironing
instructions or on fabric label.
LABEL
TYPE OF TEXTILE
Do not iron this article
•
Synthetics, Nylon, Acrylics, Polyester,
Rayon
••
Wool, Silk
•••
Cotton, Linen
www.scarlett.ru
• Insert the mains plug into the wall socket. The
indicator light will turn on.
• When the indicator light goes out you may start
ironing
• If you set the temperature control to lower setting
after ironing at a high temperature, it is not
recommended to iron before the pilot light switches
on again.
WATER TANK FILLING
• Unplug the iron before filling the water tank.
• Hold the steam iron in horizontal position.
• Slowly pour water through the water inlet.
• Do not fill higher than mark on the water tank, in
order to avoid water spilling.
NOTE: Your steam iron is designed to use tap water.
However, if the water is very hard, it is advisable to
use distilled water.
• The water tank should be emptied after each use.
NOTE: If you empty the water tank after the steam
iron has cooled down, set the steam iron in an
upright position on its heel rest, plug it in and set
the temperature control dial to the maximum
position, heat for 2 minutes. Unplug the steam iron
from the power supply.
SPRAYING
• As long as there is enough water in the water tank,
you may use the spray button at any temperature
setting during steam or dry ironing.
• Press the spray button several times to activate the
pump while you are ironing.
STEAM IRONING
• Set the temperature control dial to the "••" or "•••"
position.
• Set the variable steam control to the desired
position.
WARNING: The iron gives off steam continuously
only if you hold the iron horizontally. You can stop
the continuous steam by placing the iron in a
vertical position or by moving the steam selector to
". To prevent water dripping steam function
"
available at the highest temperatures only.
CAUTION: Avoid coming in contact with ejected
steam.
DRY IRONING
• The steam iron can be used on the dry setting with
or without water in the water tank, however it is
best to avoid having the water tank full while dry
ironing.
• Turn the variable steam control to the minimum
position.
• Select the setting on the temperature control dial
best suited for the fabric to be ironed.
CAUTION: If the steam iron has been used for a long
time, it is hot and there is no water. Do not refill it
with water until the steam iron cools down.
BURST OF STEAM
• The burst of steam feature provides additional
steam for removing stubborn wrinkles.
• Turn the temperature control dial to the "••" or "•••"
position.
• Turn the variable steam control to the maximum
position.
• Press the powerful steam button to release the
burst of steam.
4
IM005
SC-1136S
Werbung
Inhaltsverzeichnis
