After Use; Opening The Canister (Dust Compartment); Motor Protection Filter; Exhaust Filter - Nilco RS 17 A-45 Bedienungsanleitung

Opening the canister
Lid closing stop
Replacement of the dust bag
Replacement of the

motor protection filter

Replacement
of the exhaust filter

After use

To replace the filter or dust bag, push up the latch of
the canister and remove the front of the canister (dust
compartment lid).
The lid closing stop prevents the lid from closing and
also prevents operation of the appliance without a dust
bag or when the dust bag is inserted incorrectly.
Open the dust compartment and remove the full dust
bag. Place a new dust bag with the holding disk on the
connection piece in the canister and push it back as far
as it will go.
After changing the dust bag five times or if very dirty, you
have to clean or wash out the motor protection filter,
or replace it if very dirty. Only once the filter has fully
dried is it ready to be re-used.
The filter has to be changed once the dust bag has been
changed five times or if very dirty. Remove the filter
cassette from the guiding device by pulling it upwards.
Replace the filter, close the cassette and insert into the
guide as far as it will go.
en
15