Storage - Texas A/S Snow King 565 TG Anleitung

Draining fuel sediment cup
The sediment cup prevents dirt and water from entering the carburetor. If the engine has not been
engaged over a period time, the sediment cup should be cleaned before use.

Turn the fuel valve to the off position.

Remove the sediment cup using a 10 mm wrench.

Remove the o-ring and filter.

Clean each of the parts in a high flash-point solvent.

Reinstall the filter, o-ring, and sediment cup. Tighten with 10 mm wrench to secure.

Return the fuel valve to the ON position and check for leaks
Sediment cup assembly
Draining the carburetor

Loosen the carburetor drain screw.

Allow gasoline to drain completely into suitable container.

Re-tighten drain screw.

8. Storage

Storage preparation
Proper preparation for long term storage is essential for keeping your snow blower free from rust
corrosion and prevent part and function to parts impair. The following steps will make the engine
easier to start after storage and prevent your snow blower from rusting during long term period.
Cleaning
If the engine has been running, allow it to cool for at least half an hour before cleaning. Clean all
exterior surfaces, seal up any damaged paint, and coat other areas that may rust with a light film of
oil.

Using a garden hose or high-pressure cleaner can force water into the air cleaner or muffler
opening. Water in the air cleaner will soak the air filter, and water that passes through the
air filter or muffler can enter the cylinder, causing damage.

Water contacting a hot engine can cause damage and in worst case crack the aluminum
parts in the engine. If the engine has been running, allow it to cool for at least half an hour
before washing.
Drain Screw Drain Screw
29