Mounting - Texas A/S Snow King 565 TG Anleitung

3. Mounting

STEP 1 - Mounting the handles.
Mount the handlebar onto the engine block. Fasten the two bolts already mounted from the factory
to the engine block.
STEP 2 - Chute bracket and auger adjustment rod.
Chute bracket
Mount the chute bracket with attached bolt and nut on the left handlebar
Auger adjustment rod
Insert auger rod through bracket and further onto the shaft and lock with cotter pin.
STEP 3 - Mounting the cables
Pull drive and auger cable through holes from the inside of the handlebar. Loosen the cable so the
hook can be mounted in the handles and tighten rigging screw.
Adjusting the clutch and drive cable
It will be necessary to adjust the cables in order to have the right traction and auger rotation. The
rigging screw should be tightened until there is slack in the cable. The cable must be in emergen-
cies could trigger the dead man lever, when the cable is released. Ensure that the Snowbuster is
jacked during this adjustment. Jacking the Snowbuster will prevent it from moving in case the
cables are too loose. Start the engine. Engage the drive handle this should activate the wheels. If
the wheels are not running, tighten the rigging screw. Always make sure the cable is adjusted so
that the machine comes to full stop when the dead man lever released.
Adjusting the auger cable
Tighten the rigging screw until there is enough tension in the cable. The cable must in emergencies
trigger dead man lever when released. Let the machine run through the snow and release the au-
ger handle. If the auger is still rotating, retighten the rigging screw.
21